On another note, May I know how do you get your rig reports like below? Rig 3 card doing 32 is the one that started as the 31.5 v2 BIOS, the slow 2 are the sapphire's and the other 2 are xfx cards using the 31.5
Rig 4 xfx card is flashed with the 32…
I prefer to use VNC, because for me TeamViewer isn't secure enough. You can also make VNC more secure, when you use it with the SSH. You can find a lot of information in the internet about that.
Nice suggestions, guys! Gonna try out TightVNC! my e…
Dual Mining on the above setting will put my rig at almost 1100W @ the wall, and I am on a single 1050W PSU, had to drop em down to single mining mode for now.
pulling 1100w at the wall is perfectly fine on a 1050w output PSU.
alrighty! Running …
Had managed to tune Memory power down to 925mv, currently 900W @wall, Eth only.
Still hitting close to 1030W when dual mining..
I should not let my psu run over its limit constantly yea? Using a single 1050W Platinium psu.
I have finally got all 6 cards running on 31.25 Boysie Rom
Only adjustment made is 950mv on Mem for all 6cards. Single mining Eth only.
910W @ Wall
I have gone back to single mining ETH as the rates are up and…
Ahh nice, I am using a 1050W PSU as well. So I presume you are using the low power mod bios yea?
Let me summarise what you did.
1. You flashed all cards with Low Power Mod bios.
2. Set Wattman or Claymore for Power Limit +10…
I have tried to get this flashing method to work. I have tried the instructions by both boysia and heliox. I am able to flash the card and copy the driver, and I have used test mode in Windows 7 and tried Windows 10 booting with dri…