MSI RX470 4GB only 11mh/s

Comments

• EtherminerJay Member Posts: 157 ✭

  August 2017

  What's your system setup
  
  What drivers are you running

  0 · Share on FacebookShare on Twitter
• therock Member Posts: 45 ✭

  August 2017

  yea, curious too

  0 · Share on FacebookShare on Twitter
• danielehrhardt Member Posts: 11 ✭

  August 2017 edited August 2017

  

  EtherminerJay said:

  What's your system setup
  
  What drivers are you running

  I have a 750w powersupply
  Gigabyte motherboard
  4gb ram
  Win 10 64bit
  Overclock with MSI afterburner
  
  I have the new beta drive from 11. August with the blockchain dag size fix
  
  
  Now I have 15 on stock but can't really overclock it
  

  0 · Share on FacebookShare on Twitter
• EtherminerJay Member Posts: 157 ✭

  August 2017

  Have you flashed the bios on your card?
  
  Have you checked msi afterburner to make sure the clock is not set super low after blockchain driver was installed

  0 · Share on FacebookShare on Twitter
• blackice Member Posts: 52 ✭

  August 2017 edited August 2017

  maybe you have to plug a device into hdmi port.
  there is issue with people who get 0 mhs without hdmi plugin into

  0 · Share on FacebookShare on Twitter
• EtherminerJay Member Posts: 157 ✭

  August 2017

  @blackice, it must be connected to a screen if you take a look at his screen shot below

  0 · Share on FacebookShare on Twitter
• EtherminerJay Member Posts: 157 ✭

  August 2017

  It doesn't look like your installation of the new blockchain driver has worked, looking at your msi afterburner screen shot.
  
  I use the blockchain driver and it shows the driver name as CRIMSON BETA may be worth doing ddu driver uninstall and then reinstalling the blockchain driver again

  0 · Share on FacebookShare on Twitter
• danielehrhardt Member Posts: 11 ✭

  August 2017

  @blackice thank you for your reply as @EtherminerJay says i have connected a monitor to the graka
  
  @EtherminerJay the cards are not bios modded but i have done this and have the same hashrate
  
  yes correct on this image i installed the offical driver to test if the hashrate is better, but it is not
  
  

  0 · Share on FacebookShare on Twitter
• EtherminerJay Member Posts: 157 ✭

  August 2017

  Hmm, it's strange. Try running this - https://www.monitortests.com/atikmdag-patcher-1.4.5.zip
  
  I have issues with BIOS modded cards sometimes, until I run the above.
  
  Give it a go and let me know

  0 · Share on FacebookShare on Twitter
• npittas Member Posts: 26 ✭

  August 2017

  1st you are dual mining Eth and SIA. That means you need to adjust -dcri value to find a balance between the two coins. Press the + or - while claymore is mining, in order to adjust the value and when you find a hotspot for both coins, use the -dcri flag to make it permanent in your start.bat
  If none of this make sense to you, please refer to the readme.txt
  When you dual mine, eth will be lower than expected for the rx470 cards since the card has to share resources with the second coin. Try solo mining and post the results with the same configuration. Also be aware that MSI AB beta 15 works with the latest driver. Beta 16 does not work well

  0 · Share on FacebookShare on Twitter
• danielehrhardt Member Posts: 11 ✭

  August 2017

  @npittas yes thank you i will test solo mining only thank your!!! i think that is the problem
  i will write later

  0 · Share on FacebookShare on Twitter