Claymore stopped working

Buddy

Hello,

This is my first post. I just started mining. I can just hear the heads banging on desks upon reading this. I'm using an AMD Radeon RX580 with NanoPool / Claymore. I know it was working fine, because I received an email showing I had mined some Etherium. However the email also said my worker had gone offline.

Now, whenever I try to start it back up, I get that little black command window for about 1 second, and then nothing happens. Claymore won't start.

I tried changing to the Jaxx wallet... it worked for a few minutes then Claymore stopped again and I wound up in the same predicament.

Could any one of you wizards please enlighten my beginner-ass on this? I have no idea where to start.

______________________________

My environment variables appear to be the same as what Claymore specifies.

______________________________

Here is what my config file says:

# WARNING! Remove "#" characters to enable lines, with "#" they are disabled and will be ignored by miner! Check README for details.

_____________________________

Here are the last lines from my log file:

03:01:41:924 fc Cannot get Overdrive capabilities for adapter 0
03:01:45:206 fc Cannot get Overdrive capabilities for adapter 0
03:01:45:206 fc Cannot get Overdrive capabilities for adapter 0
03:01:45:206 fc em hbt: 0, fm hbt: 0,
03:01:45:206 fc watchdog - thread 0, hb time 88688
03:01:45:206 fc WATCHDOG: GPU 0 hangs in OpenCL call, exit
03:01:45:206 fc watchdog - thread 1, hb time 88907
03:01:45:206 fc WATCHDOG: GPU 0 hangs in OpenCL call, exit
03:01:45:206 fc Cannot get Overdrive capabilities for adapter 0
03:01:46:347 fc Restarting OK, exit...


Thank you very much,

Buddy